Friday, November 22, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1558

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1558



瀚慖f not within the specified value, refer to Range Selector Lever Cable Adjustment (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Shift Linkage/Shift Cable/Adjustments) and Transmission Adaptive Functions (See: Transmission and



Drivetrain/Automatic Transmission/Transaxle/Description and Operation/AF40-6 - Automatic Transmission/Transmission Adaptive



Functions).



3. Ignition ON, observe the scan tool Transmission Range Switch parameter while slowly moving the gear shift lever from Park and through all



ranges. Verify the gear shift lever position matches the scan tool parameter.



瀚慖f not within the specified value, replace the K71 Transmission Control Module.



4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



瀚慖f the DTC resets, replace the K71 Transmission Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and programming.



P0707



DTC P0706-P0708



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0706



- Park/Neutral Position Switch Circuit



DTC P0707



- Park/Neutral Position Switch Circuit Low Voltage



DTC P0708



- Park/Neutral Position Switch Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



Shift position switch function is installed as one part of transmission control module (TCM). The position switch consists of 2 switches, whose



values are running in the opposite direction. Automatic transmission shift range is calculated by TCM reading output voltage from gear lever



position sensor installed in TCM itself.



Conditions for Running the DTC

No comments:

Post a Comment