2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1225

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1225

3. Test for 2.6-4.6 V between the appropriate fuel injector control circuit listed below and ground.

* Injector 1 terminal 3

* Injector 2 terminal 6

* Injector 3 terminal 4

* Injector 4 terminal 7

* Injector 5 terminal 5

* Injector 6 terminal 8

瀚慖f less than the specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the K20 Engine Control Module.

瀚慖f greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K20 Engine Control

Module.

4. Probe the appropriate fuel injector control circuit listed below with a test lamp connected to B+. Engine cranking, verify the test lamp flashes.

* Injector 1 terminal 3

* Injector 2 terminal 6

* Injector 3 terminal 4

* Injector 4 terminal 7

* Injector 5 terminal 5

* Injector 6 terminal 8

瀚慖f the test lamp remains OFF, test the control circuit for a high resistance. If the circuit/connections test normal, replace the K20 Engine

Control Module.

Note: Testing for steps 5 and 6 is performed on the fuel injector side of the multi-way harness connector. It may be necessary to remove the

intake manifold to isolate the condition.

5. Ignition OFF, test for infinite resistance between the ignition voltage circuit terminal listed below and ground.

* Injector 1 terminal 3

* Injector 2 terminal 6

* Injector 3 terminal 4

* Injector 4 terminal 7

* Injector 5 terminal 5

* Injector 6 terminal 8

瀚慖f not the specified value, repair the ignition voltage, or control circuit, for a short to ground. If the circuits/connections test normal, test

or replace the appropriate Q17 fuel injector.

6. Test for 12-16 ohm between the appropriate ignition voltage circuit terminal 1 or 2 and each fuel injector control circuit listed below.

* Injector 1 terminal 3

* Injector 2 terminal 6

* Injector 3 terminal 4

* Injector 4 terminal 7

* Injector 5 terminal 5

* Injector 6 terminal 8

瀚慖f less than the specified range, test for a short between the control circuit and the ignition voltage circuit. If the circuits/connections test

normal, test or replace the appropriate Q17 fuel injector.

瀚慖f greater than the specified range, test the ignition voltage, and fuel injector control circuit, for an open/high resistance. If the

circuits/connections test normal, test or replace the appropriate Q17 fuel injector.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Fuel Injector Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Engine Control Module replacement, setup, and

programming

P0276

DTC P0201, P0202, P0203, P0204, P0205, P0206, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0273, P0274, P0276, or P0277