Thursday, November 14, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1403

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1403



Perform the BCM immobilizer learn using the Body Control Module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to



Immobilizer System Component Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and



Inspection/Programming and Relearning). The BCM should successfully complete the learn and the vehicle should start.



If vehicle starting is not restored, perform the ECM immobilizer learn using the Engine Control Module IMMO Learn in SPS. Refer to Immobilizer



System Component Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming



and Relearning).



P0520



DTC P0520



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P0520



- Engine Oil Pressure Switch Circuit Malfunction



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The engine oil pressure switch is a normally closed switch that opens with the proper oil pressure. With the ignition switch turned ON and the



engine not running, the engine control module (ECM) should detect a low signal voltage input. With the engine running, the engine oil pressure



switch opens and the ECM should detect a high signal voltage input. When the oil pressure is low, the ECM sends a message via High Speed



CAN-Bus to the body control module (BCM). The BCM then sends a message via Low Speed CAN-Bus to the instrument cluster requesting the



engine oil pressure indicator turned ON.



Conditions for Running the DTC



The engine is running.



Conditions for Setting the DTC



* The ECM detects that the engine oil pressure switch signal circuit is pulled low.



* The above condition is present for greater than 10 seconds.



Action Taken When the DTC Sets



The instrument cluster illuminates the service vehicle soon indicator and the oil pressure low indicator.



Conditions for Clearing the DTC

No comments:

Post a Comment