2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 209

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 209

The SDM sets this DTC when the SDM has received a critical fault message from the PPS module.

B0081 71

The SDM sets this DTC when the SDM has received invalid serial data from the PPS module.

Action Taken When the DTC Sets

* The SDM disables the passenger instrument cluster air bag.

* The PPS module will illuminate the Passenger Airbag On/Off indicator status as OFF.

* When the PPS module sets this DTC, the PPS module communicates with the SDM to turn the AIRBAG indicator on.

* When the SDM sets this DTC, the SDM will turn the AIRBAG indicator on.

* The SDM requests the instrument panel cluster (IPC) to illuminate the AIRBAG indicator.

Conditions for Clearing the DTC

* The condition for setting the DTC no longer exists and there is no activity on the low speed serial data circuits.

* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.

Diagnostic Aids

If either the SDM or PPS module were replaced, verify that the correct replacement part numbers were used for this vehicle.

Reference Information

Schematic Reference

SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Important:

* When removing connectors inspect for damage, corrosion or poor connection. Damage or corrosion in the following requires

repair or replacement of the affected component/connector.

* PPS module

* SDM module

* PPS module harness connector

* SDM wiring harness connector

1. Ignition ON, verify that DTC B0081 is the only DTC set in the SDM or PPS module.

瀚慖f any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).

2. Verify DTC B0081 0F, DTC B0081 3A, DTC B0081 39, or DTC B0081 71 is not set in the SDM. If any of these DTCs set in the SDM

diagnose the following: