2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 469
The ignition is turned from OFF to ON.
Conditions for Setting the DTC
* The SOC at key-on is 30 percent less than it was when the engine was last running.
* The average battery current was less than -2 amps when the ignition was OFF.
Action Taken When the DTC Sets
No actions are taken.
Conditions for Clearing the DTC
* The DTC will clear when the SOC is greater than or equal to 80 percent.
* A history DTC clears after 50 consecutive ignition cycles that the diagnostic runs and does not fail.
Reference Information
Schematic Reference
Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Refer to Battery Electrical Drain/Parasitic Load Test (See: Starting and Charging/Testing and Inspection/Component Tests and General
Diagnostics/Battery Electrical Drain/Parasitic Load Test).
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Engine Electrical - Hybrid (HP2)
DTC B1527
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1527 00
- High Parasitic Load - 12V
No comments:
Post a Comment