2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 484

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 484

Circuit/System Description

The Driver Door Module (DDM) and Passenger Door Module (PDM) supply voltage to the outside rearview mirror heater elements upon receipt of

a message from the HVAC module indicating that the rear defrost system is active. The door module supplies B+ through the driver/passenger

mirror heating element control circuit when a request is seen. Ground is applied through the driver/passenger mirror heating low reference circuit.

Conditions for Running the DTC

Battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

B1640 01

A short to voltage is detected on the mirror heating element control circuit while the heated mirrors are inactive.

B1640 02

A short to ground is detected on the mirror heating element control circuit while the heated mirrors are active.

Action Taken When the DTC Sets

The heated mirror will be disabled.

Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.

* A history DTC will clear after 40 fault free ignition cycles.

Reference Information

Schematic Reference

Outside Rearview Mirror Schematics (See: Body and Frame/Mirrors/Diagrams/Electrical Diagrams/Outside Rearview Mirror Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Outside Mirror Description and Operation (Heated Mirrors) (See: Body and Frame/Mirrors/Description and Operation/Outside Mirror Description

and Operation (Heated Mirrors))Outside Mirror Description and Operation (Power Mirrors) (See: Body and Frame/Mirrors/Description and

Operation/Outside Mirror Description and Operation (Power Mirrors))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool References

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

Ignition ON, press the rear window defogger switch. The rear window defogger and both heated mirrors should become warm.

Circuit/System Testing

1. Ignition OFF, disconnect the X3 harness connector at the appropriate door module.