2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 477

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 477

* Outside Rearview Mirror Motor Replacement (See: Body and Frame/Mirrors/Power Mirror Motor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for DDM or PDM replacement, setup, and

programming

B1590

DTC B1580 or B1590

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1580 00

- Mirror Horizontal Position Sensor Circuit

DTC B1590 00

- Mirror Vertical Position Sensor Circuit

Diagnostic Fault Information

Circuit/System Description

The Driver Door Module (DDM) and Passenger Door Module (PDM) determine the position of the outside rearview mirrors based on inputs from

two mirror position sensors, one for vertical position, the other for horizontal position. Five volts is applied to each sensor through a shared 5-volt

reference circuit and a shared low reference circuit supplies ground. Each sensor has an individual signal circuit which provides position voltage to

the DDM/PDM.

Conditions for Running the DTC

Battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

B1580

An improper voltage level is seen on the Driver/Passenger Mirror Horizontal Position Sensor Signal circuit.

B1590

An improper voltage level is seen on the Driver/Passenger Mirror Vertical Position Sensor Signal circuit.

Action Taken When the DTC Sets

Memory mirror recall functions are suspended as long as the fault is present.

Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.

* A history DTC will clear after 40 fault free ignition cycles.