2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 246

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 246

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

* EL-48569 Terminal Covers

* EL-48900 HEV Safety Kit

Circuit/System Testing

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal

Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

* Identify how to disable high voltage.

* Identify how to test for the presence of high voltage.

* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must

be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.

1. Perform the High Voltage Disabling () procedure.

2. Reconnect the 12-volt battery.

3. Ignition OFF, disconnect harness connector X1 of the drive motor generator battery control module and the PIM.

4. Ignition ON, verify that a test lamp illuminates between the wake up signal circuit of the PIM and ground, and the drive motor generator

battery control module and ground as follows:

* PIM X1 19

* BECM X1 12

瀚慖f the test lamp does not illuminate, test the circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the

SDG module.

5. Ignition OFF, verify that a test lamp does not illuminate between the PIM wake up signal circuit terminal 19 and ground.

瀚慖f the test lamp illuminates, test the circuit for a short to voltage. If the circuit tests normal, replace the SDG module.

6. If all circuits test normal, replace the SDG module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming

B137B

DTC B137B

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B137B 06

- Accessory Power Module Wake Up Circuit - short to ground or open

Diagnostic Fault Information