Sunday, November 3, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1013

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1013

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify tire pressure. Refer toSymptoms - Tire Pressure Monitoring (See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring

System/Testing and Inspection/Symptoms - Tire Pressure Monitoring).

C0775

DTC C0775

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC C0775

- Low Tire Pressure System Sensors Not Learned

Circuit/System Description

If the tire pressure sensor learn procedure has not been performed, the tire pressure monitor indicator icon on the instrument panel cluster (IPC) will

flash for 1 minute and then remain illuminated after the ignition switch is cycled ON and the IPC bulb check is complete. If equipped, the driver

information center (DIC) will also display a service tire monitor type message. Under these circumstances, DTC C0775 will be set and the tire

pressure sensor learn procedure will need to be performed for the system to function correctly.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The remote control door lock receiver (RCDLR) has not undergone the tire pressure sensor learn procedure.

Action Taken When the DTC Sets

* The tire pressure monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the

ignition switch is cycled ON and the IPC bulb check is complete.

* If equipped, the driver information center (DIC) displays a service tire monitor type warning message.

Conditions for Clearing the DTC

A current DTC will clear when the RCDLR has undergone the tire pressure sensor learn procedure and 1 ignition cycle has occurred.

Diagnostic Aids

A newly replaced RCDLR will set DTC C0775 on its initial ignition ON cycle. The tire pressure sensor learn procedure must be performed.

Reference Information

Description and Operation

Tire Pressure Monitor Description and Operation (See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Description

and Operation)

Electrical Information Reference

No comments:

Post a Comment