2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1173
4. Ignition OFF, Remove the positive connection at the 12-volt battery.
5. Measure the resistance between the X3 connector and the battery positive connection.
瀚慖f the resistance is greater than 1.0 ohm, repair the high resistance condition in the 12-volt circuit.
瀚慖f the resistance is less than 1.0 ohm, replace the battery positive cable - control module to auxiliary BEC.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* 200 Amp Mega Fuse and Auxiliary Electrical Center 12VDC Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Removal and Replacement/200 Amp Mega Fuse and Auxiliary Electrical Center 12VDC Junction
Block Replacement)
* Battery Positive Cable Replacement (12V Battery to Auxiliary BEC) (See: Starting and Charging/Battery/Battery Cable/Positive/Service
and Repair/Battery Positive Cable Replacement (12V Battery to Auxiliary BEC))Battery Positive Cable Replacement (Control Module to
Auxiliary BEC) (See: Starting and Charging/Battery/Battery Cable/Positive/Service and Repair/Battery Positive Cable Replacement
(Control Module to Auxiliary BEC))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for APM replacement, setup, and programming
P0AF0
DTC P0AEE, P0AEF, P0AF0, P0AF3-P0AF5, P0BD2-P0BD4, P0BD7-P0BD9, P0BDC-P0BDE, or P0BE1-P0BE3
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0AEE
- Drive Motor Inverter Temperature Sensor 1 Performance
DTC P0AEF
- Drive Motor Inverter Temperature Sensor 1 Circuit Low Voltage
DTC P0AF0
- Drive Motor Inverter Temperature Sensor 1 Circuit High Voltage
DTC P0AF3
- Drive Motor Inverter Temperature Sensor 2 Performance
DTC P0AF4
- Drive Motor Inverter Temperature Sensor 2 Circuit Low Voltage
DTC P0AF5
- Drive Motor Inverter Temperature Sensor 2 Circuit High Voltage
DTC P0BD2
- Drive Motor Inverter Temperature Sensor 3 Performance
DTC P0BD3
- Drive Motor Inverter Temperature Sensor 3 Circuit Low Voltage
DTC P0BD4
- Drive Motor Inverter Temperature Sensor 3 Circuit High Voltage
DTC P0BD7
- Drive Motor Inverter Temperature Sensor 4 Performance
DTC P0BD8
- Drive Motor Inverter Temperature Sensor 4 Circuit Low Voltage
DTC P0BD9
- Drive Motor Inverter Temperature Sensor 4 Circuit High Voltage
No comments:
Post a Comment