2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 756
Circuit/System Testing
1. Ignition OFF, disconnect the X2 harness connector at the left IP junction block.
2. Ignition ON, transmission in reverse, verify that a test lamp illuminates between the control circuit terminal E3 and ground.
瀚慖f the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal,
replace the BCM.
3. If all circuits test normal, test or replace the left IP junction block.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Instrument Panel Electrical Center or Junction Block Replacement - Left Side (See: Maintenance/Fuses and Circuit Breakers/Fuse
Block/Service and Repair/Removal and Replacement/Instrument Panel Electrical Center or Junction Block Replacement - Left Side)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming
B3715
DTC B3715
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3715 02
- Front Wiper Relay Drive Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) monitors the control circuit of the wiper relay. The voltage level should be low while the wiper relay is
de-energized and near system voltage when the relay is energized. After the BCM receives a low, intermittent, or mist signal from the wiper/washer
switch, it responds by applying battery voltage through the wiper relay control circuit to the coil side of the relay, energizing the WIPER Relay.
Ground is supplied at all times to the coil side of the WIPER relay.
Conditions for Running the DTC
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, November 16, 2019
2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 756
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment