Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 843

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 843

Ignition ON, perform the Pump Motor Test with a scan tool and listen/feel the Pump Motor turn ON and OFF.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.

2. Test for less than 1 ohm between the ground circuits listed below and ground:

* Terminal 38

* Terminal 13

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground:

* Terminal 25

* Terminal 1

瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the

B+ circuit fuse is open, replace the BPMV.

4. If all circuits test normal, replace the BPMV and verify DTC does not reset. If the DTC resets replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic

Control Assembly - Antilock Brakes/Service and Repair/Less than 3900 kg (8600 lb) GVW)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming

Antilock Brake System - Non-Hybrid Greater than/Equal to 3900 kg (8600 lb) GVW

DTC C0110

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0110 03

- Pump Motor Circuit Voltage Below Threshold

DTC C0110 04

- Pump Motor Circuit Open Circuit

DTC C0110 61

- Pump Motor Circuit Actuator Stuck

Diagnostic Fault Information

Circuit/System Description

The pump motor is an integral part of the brake pressure modulator valve (BPMV), while the pump motor relay is integral to the electronic brake

control module (EBCM). The pump motor relay is not engaged during normal system operation. When the antilock brake system (ABS) or traction

control system (TCS) operation is required the EBCM activates the pump motor relay and turns the pump motor ON.

No comments:

Post a Comment