2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1018
The trailer brake control module circuit reference voltage for the trailer brake control relay is below 4.8 V or above 5.2 V.
C1112 00
* The trailer brake control module detects a short to ground, open or a short to voltage on the integrated trailer brake relay control active low
circuit.
* The trailer brake control module detects an open in the battery positive voltage circuit to the trailer brake control relay.
* The trailer brake control module detects an open in the ground circuit to the trailer brake control relay.
* The trailer brake control module detects a short to ground or open in the solid state relay enable circuit.
C1113 01
* The trailer brake control module detects a short to voltage in the solid state relay enable circuit.
* The trailer brake control module detects a short to voltage in the trailer brake output supply voltage control circuit.
C1114 00
The trailer brake control module detects a short to ground, open or a short to voltage on the solid state relay output circuit.
C1119 00
The trailer brake control module detects a short to ground, open or a short to voltage on the relay feedback circuit.
Action Taken When the DTC Sets
* The trailer brake control will be disabled for the remainder of the ignition cycle.
* The driver information center will display Service Trailer Brake System.
Condition for Clearing the DTC
* The condition for the DTC is no longer present.
* The trailer brake control module clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
Trailer Brake Control Schematics (See: Brakes and Traction Control/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Trailer Brake Controls Description and Operation (See: Powertrain Management/Computers and Control Systems/Description and
Operation/Trailer Brake Controls Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool trailer brake controls user gain parameter. The reading should be between 0-100 percent, and change with
operating the gain switch up or gain switch down.
Circuit/System Testing
Note: These diagnostics are based on having no trailer connected.
1. Ignition ON, verify that DTC P2534 is not set.
瀚慖f the DTC is set, refer to DTC P2534 (See: P Code Charts/P2534/Wiring Systems and Power Management).
No comments:
Post a Comment