2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 501
B1600
An improper voltage level is detected on the driver/passenger mirror motor vertical control circuit while the mirror is being commanded.
B1605
An improper voltage level is detected on the driver/passenger mirror motor horizontal control circuit while the mirror is being commanded.
Action Taken When the DTC Sets
Mirror movement is suspended as long as the fault is present.
Conditions for Clearing the DTC
* A current DTC will clear when the fault is no longer present.
* A history DTC will clear after 40 fault free ignition cycles.
Reference Information
Schematic Reference
Outside Rearview Mirror Schematics (See: Body and Frame/Mirrors/Diagrams/Electrical Diagrams/Outside Rearview Mirror Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Outside Mirror Description and Operation (Heated Mirrors) (See: Body and Frame/Mirrors/Description and Operation/Outside Mirror Description
and Operation (Heated Mirrors))Outside Mirror Description and Operation (Power Mirrors) (See: Body and Frame/Mirrors/Description and
Operation/Outside Mirror Description and Operation (Power Mirrors))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool References
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Command the left and right outside mirror to move up, down, left and right using the mirror directional switch. The mirror should move in the
commanded direction.
Circuit/System Testing
1. Ignition OFF, disconnect the X3 harness connector at the appropriate door module.
2. Ignition ON, verify a test lamp does not illuminate between the following control circuit terminals and ground:
* Control circuit terminal 1
* Control circuit terminal 2
* Control circuit terminal 6
瀚慖f the test lamp illuminates, test the appropriate control circuit for a short to voltage.
3. Ignition OFF, test for infinite resistance between the following control circuits and ground:
* Control circuit terminal 1
* Control circuit terminal 2
* Control circuit terminal 6
瀚慖f less the specified value, test the appropriate control circuit for a short to ground.
4. Test for 40-100 ohms between the control circuit terminal 1 and the control circuit terminal 6.
No comments:
Post a Comment