Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 853

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 853

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0131 00

- ABS Pressure Circuit

DTC C0131 3A

- ABS Pressure Circuit Incorrect Component Installed

DTC C0131 4B

- ABS Pressure Circuit Calibration Not Learned

Circuit/System Description

The electronic brake control module (EBCM) uses input from the brake pressure sensor for more accurate control during a vehicle stability

enhancement system (VSES) event.

Conditions for Running the DTC

* Ignition ON.

* Ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

C0131 00

* Sensor supply voltage is less than 4.5 volts or greater than 5.3 volts for more than 1 sec.

* Sensor signal voltage is less than 0.12 volts or greater than 3.2 volts for more than 1 sec.

C0131 3A or 4B

EBCM has been replaced and the calibration to the brake pressure sensor has not been programmed or is outside of programed range.

Action Taken When the DTC Sets

* The EBCM disables the ABS/traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition

cycle.

* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

A DTC C0131 can set if the ECU is loosely attached to the hydraulic unit. The mountings should be checked for the proper torque.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

No comments:

Post a Comment