2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 790

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 790

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B3894 5A

- Stop Lamp Switch Circuit Plausibility Failure

Circuit/System Description

The brake switch is hard wired to the fuel pump/trailer brake control module. The body control module (BCM) sends a brake switch status serial

data message to the fuel pump/trailer brake control module. The fuel pump/trailer brake control module compares the states of the brake switch

signal to the serial data message after a master cylinder brake pressure sensor threshold is exceeded. If the brake switch signal and the serial data

message are not in agreement or if the serial data message is not valid, a DTC will set and the trailer brake control system will be disabled.

Conditions for Running the DTC

* Battery voltage is 9.5-17 V.

* The module initialization has taken place.

* The master cylinder brake pressure exceeds threshold

Conditions for Setting the DTC

* The brake switch serial data message is not valid.

* The actual brake switch input to the fuel pump/trailer brake control module, and the serial data information for the brake switch do not match.

Action Taken When the DTC Sets

* The trailer brake control will be disabled for the remainder of the ignition cycle.

* The driver information center (DIC) will display Service Trailer Brake System.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The fuel pump/trailer brake control module clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information

Schematic Reference

Trailer Brake Control Schematics (See: Brakes and Traction Control/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Trailer Brake Controls Description and Operation (See: Powertrain Management/Computers and Control Systems/Description and

Operation/Trailer Brake Controls Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, press the brake pedal. The brake lights should illuminate and the Brake Switch Status parameter should indicate ON.

Circuit/System Testing