2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 421

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 421

- Audio Output 7 Circuit Short to Ground (LR D-Pillar)

DTC B1085 04

- Audio Output 7 Circuit Open (LR D-Pillar)

DTC B1095 01

- Audio Output 8 Circuit Short to Battery (RR D-Pillar)

DTC B1095 02

- Audio Output 8 Circuit Short to Ground (RR D-Pillar)

DTC B1095 04

- Audio Output 8 Circuit Open (RR D-Pillar)

Diagnostic Fault Information

Circuit/System Description

Each of the audio output channel circuits (+) and (-), at the radio and audio amplifier have a DC bias voltage that is one half of the battery voltage.

When using a DMM, each of the audio output channel circuits will measure approximately 6.5V DC. The audio being played on the system is

produced by a varying AC voltage that is centered around the DC bias voltage on the same circuit. The AC voltage is what causes the speaker cone

to move and produce sound. This voltage will vary depending on what type of audio is being listened to, talk or music, and type of music, as well as

the volume setting of the system. Low volume and talk settings will measure around 1V AC and less, where constant music may measure 3V AC

and slightly higher.

Conditions for Running the DTC

The radio is ON.

Conditions for Setting the DTC

Set by Radio

The radio sets a current status for this DTC when a short to ground, short to voltage or an open is detected on any of the speaker channel outputs

from the radio.

Set by Bose Amplifier

The DTC will not set during normal amplifier operation. The vehicle must have the ignition OFF for several hours and the fault must be present

during amplifier power-up.

DTC B1025 01, B1035 01, B1045 01, B1055 01, B1065 01, B1075 01, B1085 01, B1095 01

A short to voltage is detected on the specified (+) or (-) signal circuit

DTC B1025 02, B1035 02, B1045 02, B1055 02, B1065 02, B1075 02, B1085 02, B1095 02

A short to ground is detected on the specified (+) or (-) signal circuit

DTC B1025 04, B1035 04, B1045 04, B1055 04, B1065 04, B1075 04, B1085 04, B1095 04

An open is detected on the specified (+) or (-) signal circuit