2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1169

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1169

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

EL-48900 HEV Safety Kit

Circuit/System Verification

1. Verify that no hybrid powertrain control module (HPCM) or engine control module (ECM) DTCs are set that indicate generator, HPCM, or

battery failure, or that disable the high voltage.

瀚慖f the specified DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).

2. Engine running or autostop, observe the scan tool accessory DC power control module (APM) HPCM 300V Circuit parameter. The reading

should be between 225 V and 380 V.

瀚慖f not within the specified range, refer to Jump Assist ().

3. Ignition ON, observe the scan tool ACCM High Battery Voltage parameter. The reading should be between 225 V and 380 V.

Circuit/System Testing

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection.

Personal Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

* Identify how to disable high voltage.

* Identify how to test for the presence of high voltage.

* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures

must be followed.

Failure to follow the procedures exactly as written may result in serious injury or death.

1. Disable the high voltage, and remove the 3 phase cable cover. Refer to High Voltage Disabling ().

2. Ignition OFF, verify that the air conditioner compressor HVDC terminal bolts are present and are torqued to specification.

瀚慖f the bolts are missing or are not tight, replace any damaged components, install and tighten the bolts.

3. If all circuits test normal, replace the ACCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for ACCM replacement, setup, and programming

P0AFB

DTC P0AFB

Diagnostic Instructions