2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 685

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 685

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.

5. If all circuits test normal, replace the component with the inoperative backlighting.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Refer to the appropriate replacement procedure for the component causing the condition.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

B2705

DTC B2705

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2705 02

- Gearshift Unlock Circuit Short to Ground

Diagnostic Fault Information

Circuit/System Description

The body control module (BCM) controls the automatic transmission shift lock control solenoid by providing a battery positive voltage to the

solenoid. The BCM utilizes a smart driver to control the voltage supply circuit to the automatic transmission shift lock control solenoid. The smart

driver monitors the voltage and current flow of the control circuit.

Conditions for Running the DTC

* The ignition switch is in the ON position.

* The brake pedal is pressed.

* The transmission is in the PARK position.

Conditions for Setting the DTC

The DTC sets if there is a short to ground in the automatic transmission shift lock control solenoid control circuit.

Action Taken When the DTC Sets

The BCM will not attempt to enable the voltage supply circuit of the automatic transmission shift lock control solenoid until the next key cycle.

Conditions for Clearing the DTC

* A current DTC B2705 will clear when the malfunction is no longer present and the ignition switch is cycled.

* A history DTC will clear after 100 ignition cycles with no current DTC active during the 100 ignition cycles.

Reference Information

Schematic Reference

Shift Lock Control Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift Interlock/Diagrams/Electrical

Diagrams)

Connector End View Reference