2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 686

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 686

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Automatic Transmission Shift Lock Control Description and Operation (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Shift Interlock/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition ON, clear the DTC. Observe the scan tool BCM Stop Lamp Relay Command parameter while pressing and releasing the brake pedal.

The parameter should change between ON and OFF.

瀚慖f the parameter does not change between the specified values, refer to Stop Lamps Malfunction (See: Lighting and Horns/Testing and

Inspection/Stop Lamps Malfunction).

2. Press the brake pedal, the vehicle operator should be able to move the shifter out of the PARK position.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the shift lock control solenoid.

2. Ignition OFF, test for less than 5.0 ohm between the ground circuit terminal B and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Install a test lamp between the ground circuit terminal B and the control circuit terminal A.

4. Ignition ON, command the scan tool BCM Shift Lock Solenoid output control ON and OFF. The test lamp should turn ON and OFF as

commanded.

瀚慖f the test lamp is always ON, test the control circuit for short to voltage. If the circuit tests normal, replace the BCM.

瀚慖f the test lamp is always OFF, test the control circuit for short to ground or an open/high resistance. If the circuit tests normal, replace the

BCM.

5. If the circuit tests normal, replace the transmission control.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Automatic Transmission Shift Lock Control Actuator Replacement (See: Powertrain Management/Transmission Control Systems/Actuators

and Solenoids - Transmission and Drivetrain/Actuators and Solenoids - A/T/Shift Interlock Solenoid/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

MP 3010-NP0 - Transfer Case

DTC B2725

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.