Friday, November 15, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 673

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 673

The BCM will disable the DRL relay control circuit.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System

Diagram/Headlights/Daytime Running Lights (DRL) Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems Description

and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

Warning

The high intensity discharge system produces high voltage and current. To reduce the risk of severe shocks and burns:

* Never open the high intensity discharge system ballast or the arc tube assembly starter.

* Never probe between the high intensity discharge system ballast output connector and the arc tube assembly.

1. Ignition OFF, disconnect the X4 harness connector at the fuse block - underhood.

2. Connect a test lamp between the control circuit terminal H4 and B+.

3. Command the DRLs ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

4. Ignition OFF, connect the X4 harness connector at the fuse block - underhood. Disconnect the harness connector at the daytime running

lamp.

5. Test for less than 5 ohm between the daytime running lamp ground circuit terminal listed below and ground:

* With X88 - Terminal C

* With Z75 and Z88 - Terminal B

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

6. Connect a test lamp between control circuit terminal A and ground:

7. Command the DRLs ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the fuse block - underhood.

瀚慖f the test lamp is always OFF and the circuit fuse is good, test the control circuit for an open/high resistance. If the circuit tests normal,

test or replace the fuse block - underhood.

瀚慖f the test lamp is always OFF and the circuit fuse is open, test the control circuit for a short to ground. If the circuit tests normal, test or

replace the daytime running lamp.

No comments:

Post a Comment