YES
The measurement values are OK.End of test
NO
The measurement values are not OK.Possible cause and remedy
- B2/5b1 (Intake air temperature sensor)
End of test
2. Check component B14 (Ambient temperature display temperature sensor).
Test 2.1: Check component B14 (Ambient temperature display temperature sensor).
2.1. Check component B14 (Ambient temperature display temperature sensor).
Test prerequisites
- The power supply of component N10/1 (Driver-side SAM control unit with fuse and relay module) is OK.
- Fault code 9063 is current, and (or) at least one of the relevant actual values is not OK.
Test sequence
- Detach coupling at component B14 (Ambient temperature display temperature sensor).
- Connect resistance simulator to the connector of component B14 (Ambient temperature display temperature sensor).
- Connect resistance substitution unit between sockets (B14)1 and (B14) 2
- Adjust resistance values one after another and compare them with the actual value.
Status of relevant actual value:
- B14 (Ambient temperature display temperature sensor):Warning! Communication with ECU required.
Specified value
- Resistor9.6 kohms:Temperature: [0锟斤拷 C]
- Resistor5.9 kohms:Temperature: [10锟斤拷 C]
- Resistor3.7 kohms:Temperature: [20锟斤拷 C]
- Resistor2.4 kohms:Temperature: [30锟斤拷 C]
- Resistor1.6 kohms:Temperature: [40锟斤拷 C]
Question:Is the actual value o.k.?
No comments:
Post a Comment