Tuesday, September 3, 2019

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S418-01 Date: 990901

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S418-01 Date: 990901



Brake Pedal Switch - Revised and Installation



S418-01



DATE 9/99



MODEL



2000 MY-ON S-TYPE



VIN



L00001-ON



Brake Pedal Switch - Revised Specification - Installation Procedure



Issue:



From VIN L06314 a revised brake switch has been used in production. In the event of replacement being required on earlier vehicles, install the



revised brake switch. Due to a modification that allows greater travel of the plunger, the appropriate installation procedure, as described below,



should be followed.



Action:



The following procedures apply:



VEHICLES UP TO VIN L06313



If the Brake Switch (Grey Casing) is faulty, it is necessary to replace the switch with latest specification switch as described below.



If the Cruise Control De-activation Switch (Blue Casing) is faulty, it is necessary to replace the switch (no change in specification) along with a



replacement latest specification brake switch, as described below.



VEHICLES FROM VIN L06313



It is only necessary to replace the faulty switch, but the new installation procedure must be followed.



INSTALLATION PROCEDURE



1. Remove the faulty switch (or both switches in case the Cruise Control De-activation Switch is faulty on vehicles prior to VIN L06313).



2. Press the brake pedal downwards as far as possible and hold it in this position. The Jaguar Brake Pedal Holding Tool JDS 9013, part of the



Jaguar Special Equipment, Brake System Power Hydraulic Test kit, may be used for this purpose. Similar proprietary tools are also available



from other suppliers.



3. Install the new switch(es) with the pedal held in the down position.



4. Unlock the safety catch(es) on the switch(es) by rotating the tag on the rear of the switch(es).



5. Release the brake pedal and allow the brake pedal to come to rest. As this occurs, the switch plunger(s) will ratchet inwards.



2000 Jaguar S-Type (X200) V6-3.0L Page 151



6. Pull the brake pedal carefully upwards until one click is heard to come from the brake switch, then release the pedal.



7. Check for correct operation of the switch(es).



Parts Information:



DESCRIPTION PART NUMBER



Cruise Controt De-activation Switch XR8 1616



Brake Switch C2C 1074



Warranty Information:



FAULT R.O. TIME



CODE NUMBER DESCRIPTION ALLOWANCE



BL BJ ** 19.75.20 Replace Cruise De-activation Switch 0.15 hrs.



QN FB ** 86.65.51 Replace Brake Light Switch 0.15 hrs.



86.65.52 Replace BOTH above switches. 0.20 hrs.

No comments:

Post a Comment