Tuesday, September 17, 2019

DisclaimerJaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S211-02 Date: 990901

DisclaimerJaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S211-02 Date: 990901



Steering Wheel - Replace Leather W/Wood and Leather



S211-02



DATE 9/99



MODEL



2000 MY-ON S-TYPE



VIN



See VIN List



Steering Wheel - Replace Leather Steering Wheel With Wood & Leather Steering Wheel - Service Action S106



Issue:



Due to the huge worldwide demand for the new S-TYPE, some vehicles within VIN range L04098-L28711 were built with a leather rimmed steering



wheel, rather than the wood and leather steering wheel originally specified. Jaguar has identified each vehicle that will require the installation of a



replacement wheel. Each dealership will receive a listing of all vehicles affected that have been retailed by that dealership. All the necessary parts



will be automatically shipped to the dealership on a free of charge basis.



Action:



Replace leather rimmed steering wheel with the wood and leather steering wheel as originally specified as standard equipment.



PROCEDURE FOR REPLACING LEATHER STEERING WHEELS



1. DISCONNECT THE NEGATIVE LEAD FROM THE BATTERY. IT MUST REMAIN DISCONNECTED UNTIL STEP 16 OF THIS



PROCEDURE.



2. Allow 1 minute to elapse for air bag circuitry to disarm before continuing.



3. Remove the plastic covers to gain access to the two screws that retain the driver's air bag. Remove the screws.



4. Lift the air bag until its multiplug can be disconnected and place the air bag clear of the working area.



5. Disconnect the multiplug from the horn switch.



2000 Jaguar S-Type (X200) V6-3.0L Page 157



6. Loosen, but do not remove completely, the 4 screws that retain the horn switch. The screws should remain in the horn switch as they do not



need to be fully backed out to remove the horn switch from the steering wheel.



7. Loosen (but do NOT remove) the steering wheel securing Torx bolt. (4 - 5 turns).



8. Fit the drive screw of puller (Special Tool 303-D121) into the cupped end of JD10/2. Align the flat side on the head of the retaining bolt of the



steering wheel. Operate the puller in the two leg configuration to release the steering wheel from the taper on the column. It may be necessary



to prevent the steering wheel screw from rotating by holding the bolt with pliers.



9. Remove the puller from the wheel; remove and discard the steering wheel securing bolt. Remove the steering wheel.



10. Align and install the replacement steering wheel, threading the multiplugs and harness through the wheel.



11. Install a NEW steering wheel securing screw and fully tighten it. Torque wrench setting: 35 Nm.



12. Connect the air bag multiplug, align the air bag and install and tighten the securing screws. Torque wrench setting: 9 Nm.



13. Reinstall the plastic covers to the air bag securing screw apertures.



14. Reconnect the battery.



15. Reset the clock.



Parts Information:



Wood/Leather steering wheels and bolts will be shipped directly to each dealer free-of-charge. These shipments are based from the color/trim



specification of the vehicles affected by this action allocated to your dealership.



Warranty Information:



RECORD KEEPING



Receipts for the services pertormed must be kept in conjunction with warranty audit requirements; refer to section H-3.8 of the Warranty Policies



and Procedures Manual.



NOTE:



Always perform a DCS claim search first to determine whether this service action has been performed on this vehicle. The warranty selection



under the vehicle inquiry will give a listing of all claims against the vehicle. If S106 appears in the fault code field, do not perform this service



action.



CLAIM SUBMISSION PROCEDURE:



Warranty summary codes have been assigned to this service action in order to simplify claim submission. The dealership will be reimbursed the parts



and labor time allowance as indicated.



DCS DEALERS



2000 Jaguar S-Type (X200) V6-3.0L Page 158



Submit claims using the appropriate summary code for the vehicle model and work performed. Follow standard campaign submission procedures.



NON-DCS DEALERS



Submit claims on the Recall Campaign Summary form W-25. Enter the appropriate summary code for the vehicle model and work performed in the



Repair Code column. Do not use the W-1 warranty claim form.



Vehicle Requiring Steering Wheel Replacement VIN List



VEHICLES REQUIRING STEERING WHEEL REPLACEMENT



VIN List 1 - 8 (Dealer# on Left, Vin# on Right) ea. column.



2000 Jaguar S-Type (X200) V6-3.0L Page 159



2000 Jaguar S-Type (X200) V6-3.0L Page 160



2000 Jaguar S-Type (X200) V6-3.0L Page 161



2000 Jaguar S-Type (X200) V6-3.0L Page 162



2000 Jaguar S-Type (X200) V6-3.0L Page 163



2000 Jaguar S-Type (X200) V6-3.0L Page 164



2000 Jaguar S-Type (X200) V6-3.0L Page 165

No comments:

Post a Comment