Thursday, September 5, 2019

2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 800


- Is the measurement value OK?



YES



The measurement value is OK.End of test



NO



The measurement value is not OK.Possible cause and remedy



- N10/1f57 (Fuse 57)



- N10/1kI (Circuit 87 relay, engine)



- Line from component N3/10 (ME-SFI [ME] control unit) to component Y58/1 (Purge control valve)



- Line from component N10/1 (Driver-side SAM control unit with fuse and relay module) to component Y58/1 (Purge control valve)



- Y58/1 (Purge control valve)



End of test



2.1.5.3. Perform mechanical inspection of component Y58/1 (Purge control valve).



Figure legend



- 019Vacuum tester



- Y58/1 (Purge control valve)



Test prerequisite



- Actuation is OK.



Test sequence



- Switch off ignition.



- Connect the vacuum tester to the input of component Y58/1 (Purge control valve) with the 3 x distributor.



- Operate engine at idling speed.



- Engine at operating temperature



- Actuate component Y58/1 (Purge control valve), then with key F2.



Warning!Communication with ECU required.



2.1.6. Check signal from component B2/5 (Hot film mass air flow sensor) via actual value.



Test 2.1.6.1: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.



Test 2.1.6.2: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.

No comments:

Post a Comment