Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S501-06 Date: 001001

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S501-06 Date: 001001

Interior - Window Switch Buttons Hot to Touch

S501-06

S-Type

DATE

10/00

MODEL

2000 MY-ON

S-TYPE

VIN

L00001-ON

Memory Buttons Hot To Touch - Component Serviceability - Repair Procedure

Issue:

Lower wattage bulbs and window isolation buttons are now available to address customer complaints of the following:

^ Excessively hot memory buttons in the window switch pack - hot to touch.

^ Missing window isolation button.

2000 Jaguar S-Type (X200) V6-3.0L Page 109

Note:

The bulbs within the switch pack (Illustration 1) should only be replaced for the above complaint or if they are faulty or blown. Vehicles up to

VIN L59837 were equipped with 100 ma bulbs for the seat memory control buttons, which then changed to 50 ma bulbs. Do not replace

complete switch packs for such complaints, as this will result in the non-payment of the warranty claim.

Action:

To replace the bulbs and/or the isolation button, follow the procedure below:

REPLACING SWITCH PACK BULBS

Record the following system settings prior to disconnecting the battery so that they may be reset to the customers preferred setting.

^ Clock time setting.

^ Clock 12/24 hour setting.

^ CD compress mode (if equipped. Radio must be in CD mode to check this setting.)

^ Navigation volume defaults to 14 (if equipped).

^ Voice feedback volume defaults to 14 (if equipped - voice training is not lost).

^ Gear box mode.

^ Radio presets AM/FM.

^ Compass calibration and zone setting.

^ Navigation memory will be retained if the battery has not been disconnected longer than 24 hrs.

The trip computers (both A & B) will reset to zero, these however cannot be returned to prior readings.

1. Disconnect the car battery (See workshop manual, JTIS CD ROM section 414-01, SRO 86.15.01).

2. Remove the door casing. (See workshop manual, JTIS CD ROM section 501-05, SRO 76.34.01).

3. Disconnect the switch pack connector.

4. Remove the armrest to expose the switch pack assembly (See workshop manual, JTIS CD ROM section 501-11, SRO 86.25.07. If SRO is not

found for 2000 MY S-TYPE, refer to 1999 MY).

5. Using a screwdriver and a small pair of pointed tweezers, remove the bulb from the switch pack assembly (Illustration 1). Replace the memory

position bulbs (item 1, Illustration 1) with 50 ma bulbs (blue base) only.

2000 Jaguar S-Type (X200) V6-3.0L Page 110

6. If necessary, install the isolation button into the switch pack ensuring it is fully depressed into the housing or until an audible click is heard.

(See item 1, Illustration 2). Button can be removed with a small pair of tweezers/pliers.

Note:

The button can either be replaced at this stage in the procedure, when the switch pack is easily accessible, or, it can be replaced while the

switch pack is still in the door casing assembly.

7. Reinstall the armrest to the door casing assembly (See workshop manual, JTIS CD ROM section 501-11 SRO, 86.25.07).

8. Reconnect the switch pack connector.

9. Reinstall the door casing. (See workshop manual, JTIS CD ROM section 501-05, SRO 76.34.01).

10. Reconnect the car battery (See workshop manual, JTIS CD ROM section 414-01, SRO 86.15.01).