Friday, August 16, 2019

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S100-07 Date: 000501

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S100-07 Date: 000501



Campaign - S126 Vacuum Routing Label Incorrect



S100-07



S-Type



DATE 05/00



MODEL



2000 MY-ON 3.0L V6



S-TYPE



VIN



L00600 - L38199



Vacuum Hose Routing Label - Replace - Service Action S126



Issue:



The vacuum routing label on 3.0L V6 2000 MY S-TYPE vehicles within the above VIN range, may be incorrect. All vehicles from VIN L38200



onwards have been equipped with the correct label during manufacture.



4.0L V8 vehicles are not covered by this Service Action. A workshop procedure is included in this bulletin.



Action:



On all 3.0L V6 S-TYPE vehicles prior to VIN L38200, install a new vacuum routing diagram label on (Illustration 1) both the right side front



suspension panel and on the right side tower cover.



Perform this action at the next convenient workshop visit.



WORKSHOP PROCEDURE



2000 Jaguar S-Type (X200) V6-3.0L Page 16



The tower cover is held in place by a plastic clip, accessible only by reaching up into the wheel arch area (Illustration 2). To release the clip



reach up into the wheel arch area above the tire and squeeze the two ends of the clip together, at the same time gently pull the tower cover off.



Caution:



Do not attempt to pull the tower cover off without releasing the clips, since this will permanently damage the cover.



Remove the existing label from the right hand side of the suspension panel and replace it with the new label, part number XR8 17391



(Illustration 3).



3. Apply a second label to the tower cover (Illustration 4).



Parts Information



2000 Jaguar S-Type (X200) V6-3.0L Page 17



Warranty Information



NOTE:



Always perform a DCS claim search first to determine whether this service action has been performed on this vehicle. The warranty selection



under the vehicle inquiry will give a listing of all claims against the vehicle. If S126 appears in the fault code field, do not perform this service



action.



CLAIM SUBMISSION PROCEDURE:



Warranty summary codes have been assigned to this service action in order to simplify claim submission. The dealership will be reimbursed the parts



and labor time allowance as indicated.



DCS DEALERS



Submit claims using the appropriate summary code for the vehicle model and work performed. Follow standard campaign submission procedures.



NON-DCS DEALERS



Submit claims on the Recall Campaign Summary form W-25. Enter the appropriate summary code for the vehicle model and work performed in the



Repair Code column. Do not use the W-1 warranty claim form.

No comments:

Post a Comment