2020 BMW 128i Coupe (E82) L6-3.0L (N51) Diagnostic Trouble Codes ( DTC ): Service instruction
none
2AB6
2AB6 - P16A5
Information saved in
DME
Fault code
2AB6 - P16A5
Fault text
DME, internal fault: multiple output-stage module
Fault description
Timeout Control Module Multiple Output Stage SPI-Bus
Condition for fault identification
Test condition:
Driver circuit monitor
Terminal condition: Terminal 15 ON Voltage condition:
none
Condition for fault memory entry
Yes, by event counter. Fault must occur ten times before a fault memory entry is made.
Action in service
Determine whether fault is stored again after carrying out the following procedure. If yes: Replace DME.
Clear fault memory
Ignition off, allow vehicle to assume complete dormant status
Ignition on
Read out stored fault codes from fault memory
Fault effect and breakdown warning
Driver information
Warning light:
No warning message. No control activation possible from some DME output terminals.
No comments:
Post a Comment