2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB00250 Date: 100115

2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB00250 Date: 100115

Suspension - Software Update After Compressor Replace

No.: LTB00250

Issue: 1

Date: 15 JAN 2010

SECTION: 204

Suspension System Software Update When Replacing

Compressor

AFFECTED VEHICLE RANGE:

CONDITION SUMMARY:

Situation:

The amber or red suspension warning indicator may illuminate with Suspension System Inactive displayed in the message center or there may be a

noticeable degradation in suspension system performance. If after diagnosis air suspension compressor failure is found and the compressor is

replaced, the Suspension system control module may require a software update.

NOTE:

Updating the suspension system control module software may only be performed after a suspension system compressor replacement.

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 284

Action:

In the event of a suspension system compressor replacement, refer to the Repair Procedure outlined below to update the suspension system control

module software.

PARTS:

No parts necessary

TOOLS:

IDS with IDS-DVD119_V8.03 or later and Calibration 21 or later Land Rover-Approved Midtronics Vehicle Power Supply

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time. This suspension system control module software update may only be performed after a

suspension system compressor replacement.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

UPDATE SUSPENSION SYSTEM CONTROL MODULE SOFTWARE

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

NOTE:

IDS must be loaded with IDS-DVD119_V8.03 or later and Calibration File 21 or later.

2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

4. From the Session screen, select the Diagnosis tab.

5. Select the Selected Symptoms tab, and then select:

^ Chassis > Suspension system > Vehicle dynamic suspension

6. Select continue.

7. Select the Recommendations tab.

8. Configure the Ride level control module.

^ Follow all on-screen instructions to complete this task.

9. Exit the current session.

10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 285