Thursday, July 25, 2019

2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB004193 Date: 120523

2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB004193 Date: 120523



Body - Door Mirror Wind Noise



TECHNICAL BULLETIN



LTB00419NAS3



23 MAY 2012



ISSUE '3' CHANGES ARE HIGHLIGHTED IN GRAY



SECTION: 501



Door Mirror Wind Noise



AFFECTED VEHICLE RANGE:



Range Rover (LM)



VIN: AA304426 - *CA383407*



Model Year: 2010 - 2012



CONDITION SUMMARY:



Situation:



A wind noise may be heard from the left or right front door mirror(s). This may be caused by air penetration between the mirror and the door mating



surface Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to insert a Nitto foam pad at the door



mirror mounting area.



PARTS:



NOTE:



The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).



Nitto foam - locally sourced from the Squeaks & Rattles Kit



TOOLS:



Refer to Workshop Manual for any required special tools



WARRANTY:



NOTE:



Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance



only. Always refer to DDW to obtain the latest repair time.



NOTE:



The Nitto foam should be locally sourced from the Squeaks & Rattles Kit and must be claimed as 'sublet' using code 'other' (up to $3.09).



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



Normal Warranty policies and procedures apply



2010 Land Rover Range Rover (LM) V8-5.0L SC Page 31



REPAIR PROCEDURE



INSTALL NITTO FOAM PAD TO MIRROR MOUNTING AREA



1. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and remove the door mirror.



2. Identify the cavity.



3. Identify the area to be covered by the Nitto foam.



CAUTION:



Make sure that the pad does not interfere with the mirror assembly.



4. Install the pad.



^ Cut the locally sourced Nitto foam from the Squeaks & Rattles Kit into a 25mm X 15mm rectangle.



^ Install in to the location shown.



5. Refer to Workshop Manual, section 501-09: Rear View Mirrors, and install the door mirror.



6. If necessary, repeat steps 1 - 5 to the opposite door / mirror.

No comments:

Post a Comment