Disclaimer2010 Land Rover LR4 (LA) V6-4.0L Technical Service Bulletin # TECLTB00345 Date: 110228

Disclaimer2010 Land Rover LR4 (LA) V6-4.0L Technical Service Bulletin # TECLTB00345 Date: 110228

Interior - Headliner May Become Detached/Poor Adhesion

No: LTB00345

28 FEB 2011

SECTION: 501

2010 Land Rover LR4 (LA) V6-4.0L Page 78

Headliner Delaminating Around Roof Opening Aperture

AFFECTED VEHICLE RANGE:

LR3 (LA)

VIN: 5A000360 - 9A513325

Model Year: 2005 - 2009

LR4 (LA)

VIN: AA510742 - Onwards

Model Year: G2010 - Onwards

Range Rover Sport (LS)

VIN: 6A900290 - 7A999999

7A100000 - Onwards

Model Year: 2006 - Onwards

CONDITION SUMMARY:

Situation:

The headliner material may become detached around the roof opening aperture. This may be caused by poor adhesion.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to apply adhesive to the headliner.

PARTS:

5TC50546 Superglue Qty: 1

TOOLS:

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply.

REPAIR PROCEDURE

APPLY SUPERGLUE TO HEADLINER

CAUTION:

Ensure tools and hands are clean to avoid damage / marking of the headliner.

1. Refer to Workshop Manual, section 501-05: Interior Trim and Ornamentation, and release and lower the headliner:

2010 Land Rover LR4 (LA) V6-4.0L Page 79

^ Inspect the headliner for damage. (Figure 1)

CAUTION:

When cutting the headliner, ensure care is taken not to cut any further than required.

2. Starting 5mm from the top edge, slice down / away from the show face of the headliner using a suitable pair of sharp scissors or a scalpel. This

will relieve the tension in the cover material and allow for easier edge wrapping and prevent it from lifting again in the future. (Figure 2)

WARNING:

Wear gloves as the glue is an irritant to the skin and can adhere your skin together.

CAUTION:

Use care to avoid damage / marking of the headliner when applying the superglue.

NOTE:

The glue will not cure until the joint is air tight. Once the joint is made, the glue will cure extremely quickly: 20 seconds to hold; 60 seconds to

totally dry.

2010 Land Rover LR4 (LA) V6-4.0L Page 80

3. Lift the delaminated cover material and apply the glue to the headliner backing. (Figure 3)

WARNING:

Wear gloves as the glue is an irritant to the skin and can adhere your skin together.

CAUTION:

Ensure no damage is caused to the headliner.

NOTE:

Insufficient tension will show up as loose material along the top edge of the roof opening aperture.

4. Pull the edge of the material tightly over the frame and push the material into the glue and hold for 60 seconds. (Figure 4)

5. Ensure the headliner is correctly repaired. (Figure 5)

6. Refer to Workshop Manual, section 501-05: Interior Trim and Ornamentation, and install the headliner.

2010 Land Rover LR4 (LA) V6-4.0L Page 81