2010 Land Rover LR4 (LA) V6-4.0L Technical Service Bulletin # TECLTB004302 Date: 120726

2010 Land Rover LR4 (LA) V6-4.0L Technical Service Bulletin # TECLTB004302 Date: 120726

Collision Avoidance - Surround Camera Image Lost

LTB00430NAS2

26 JULY 2012

ISSUE 2 CHANGES ARE HIGHLIGHTED IN GRAY AND ASTERISKS

SECTION: 418-02

Surround Camera System Camera Equalizers

AFFECTED VEHICLE RANGE:

CONDITION SUMMARY:

Situation:

On vehicles fitted with the Surround Camera System (not vehicles fitted with Parking Aid - Rear View Camera only), the camera image may be lost

and a blue screen is displayed.

Cause:

This may be caused by signal loss through the coax.

*NOTE: LR4 and Range Rover Sport vehicles experiencing a rear or front bumper camera blue screen concern and eligible for Service Action

Q179, perform the Repair Procedure as described in Technical Bulletin Q179NAS.*

NOTE:

For Range Rover vehicles experiencing a rear camera blue screen concern and eligible for Service Action Q140, perform the Repair Procedure

2010 Land Rover LR4 (LA) V6-4.0L Page 7

as described in Technical Bulletin Q140NAS. For vehicles experiencing an issue with a camera where an equalizer kit is not available, refer to

Technical Bulletin LTB00367NAS for further information.

Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install an equalizer kit(s).

PARTS:

TOOLS:

Refer to Workshop Manual for any required special tools

WARRANTY:

NOTE: Repair procedures are under constant review, and therefore times are subject to change;

those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

REPAIR PROCEDURE

INSTALL NEW SURROUND CAMERA SYSTEM CAMERA EQUIALIZERS

NOTE:

Do not replace all camera equalizers. Only install a camera equalizer to a circuit which is displaying no image / blue screen.

1. Refer to Workshop Manual, section 418-02: Wiring Harnesses, and install new camera equalizers.

2. Verify Surround Camera System camera operation:

^ If the image is lost or a blue screen is displayed, refer to Technical Bulletin LTB00367NAS for further information.