- Voltage[11.0...15.0] V
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further possible causes of fault
- Signal wire
- B6/7 (Right exhaust camshaft Hall sensor)
End of test
NO
The measurement value is not OK.Possible cause and remedy
- N10/1f43 (Fuse 43)
- N10/1kR (Circuit 87 relay, engine)
- Lines to component B6/7 (Right exhaust camshaft Hall sensor)
End of test
0765
B6/6 (Left exhaust camshaft Hall sensor) : Short circuit to positive or open circuit (P0393)
Possible cause:
- B6/6 (Left exhaust camshaft Hall sensor)
Affected functions:
- Engine diagnosis
- Engine output
-------------------------------------------------
Test 1: Check component B6/6 (Left exhaust camshaft Hall sensor).
1. Check component B6/6 (Left exhaust camshaft Hall sensor).
Test 1.1: Check component B6/6 (Left exhaust camshaft Hall sensor) using actual value.
Test 1.2: Check power supply of component B6/6 (Left exhaust camshaft Hall sensor).
Test 1.3: Check assignment of signals from Hall sensors 'Camshafts' and 'Crankshaft'.
1.1. Check component B6/6 (Left exhaust camshaft Hall sensor) using actual value.
Warning!Communication with ECU required.
1.2. Check power supply of component B6/6 (Left exhaust camshaft Hall sensor).
Test prerequisite
- The actual value is not o.k.
Test sequence
- Switch off ignition.
- Detach coupling at component B6/6 (Left exhaust camshaft Hall sensor).
- [ B6/6 ]Measure direct voltage with multimeter between sockets 1 and 3[ B6/6 ]
- Switch on ignition.
Specified value
- Voltage[11.0...15.0] V
Question
- Is the measurement value OK?
No comments:
Post a Comment