Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00288 Date: 100717

Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB00288 Date: 100717

Audio - Satellite Radio Defaults To Channel 184 From 001

NO: LTB00288

ISSUE: 1

DATE: 17 JUNE 2010

SECTION: 415

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 178

SDARS Changes From Channel 001 to 184

AFFECTED VEHICLE RANGE

CONDITION SUMMARY:

Situation:

The Satellite Digital Audio Receiving System (SDARS) may switch to channel 184 if the last listened-to channel was 001 (Hits 1) when the ignition

was switched 'OFF'. This may be caused by a software issue within the Audio front control module.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to update the Audio Front Control Module software.

PARTS:

No parts necessary

TOOLS:

IDS with latest IDS-DVD and Calibration File; first available on IDS-DVD121_V6.08 Calibration File 37 Land Rover-approved Midtronics Vehicle

Power Supply

Refer to Workshop Manual (GTR) for any required special tools

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always

refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

UPDATE THE AUDIO FRONT CONTROL MODULE SOFTWARE

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

NOTE:

IDS must be loaded with IDS-DVD121_V6.08 or later and Calibration File 37 or later.

2. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 179

4. From the Session Type selection screen, choose 'Diagnosis'.

5. Select the 'Selected Symptoms' tab, and then select:

^ Electrical > Information and entertainment system > Entertainment system > Audio > Radio loses preset stations

6. Select 'continue'.

7. Select the 'Recommendations' tab.

8. From the Recommendations tab, select 'Run' to configure the 'Audio front control module'

^ Follow all on-screen instructions to complete this task.

9. Exit the current session.

10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

11. Close all doors, tailgate, and hood.

12. Lock the vehicle; wait 10 seconds.

13. Unlock the vehicle; wait 10 seconds.

14. Repeat steps 11 and 12.

15. Verify radio (AM / FM / CD / SDARS) operation.