Friday, March 15, 2019

Interior - Cup Holder Lid Won't Open Or Close

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Technical Service Bulletin # 09-085A Date: 100528



Interior - Cup Holder Lid Won't Open Or Close



Classification: BT09-047A



Reference: NTB09-085A



Date: May 28, 2010



MAXIMA AND ALTIMA SEDAN AND COUPE; CUP HOLDER LID WILL NOT OPEN OR CLOSE



This bulletin has been amended. The title, APPLIED VEHICLES, CLAIMS INFORMATION, and the SERVICE PROCEDURE have been



amended. Discard previous copies of this bulletin.



APPLIED VEHICLES:



2009 - 2010 Maxima (A35)



2007 - 2009 Altima Sedan (L32) with M/T ONLY



2008 - 2010 Altima Coupe (CL32)



APPLIED VINS and DATES:



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 422



2009 Maxima: Vehicles built after 1N4AA51E(*)9C 855418, and 06/16/09



2010 Maxima-All



2007 - 2009 Altima Sedan-All



2008 - 2010 Altima Coupe-All



IF YOU CONFIRM:



The cup holder lid (lid) will not open or close.



ACTION:



Reattach the lid hinge.



^ For repair procedure, refer to the SERVICE PROCEDURE section of this bulletin.



NOTE



Do not replace the center console cup holder assembly for this incident, if it should occur.



IMPORTANT:



The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire Service



Procedure as it contains information that is essential to successfully completing this repair.



CLAIMS INFORMATION



SERVICE PROCEDURE



NOTE:



^ Repairs are shown performed with the cup holder out of the vehicle.



^ Repairs can be done with the cup holder in the vehicle.



^ Repairs shown are performed on the rear of the lid. Repairs to the front are similar.



^ Maxima cup holder shown; Altima Sedan/Coupe cup holders similar.



^ For Altima Sedan: Applies to M/T equipped models only.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 423



1. Open the lid by pushing on its backside (see Figure 1).



2. Align the hinge pin (pin) up to the opening at the end of the cup holder arm (arm). See Figure 2 and 3.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 424



3. Close the lid (see Figure 4).



^ Push down on the lid enough for it to stay closed by itself.



^ Make sure the arm and the pin stay aligned while closing (see Figure 5).



4. Push down on the end of the lid until the pin snaps into the arm (see Figure 5).



^ After snapping in place, make sure there is no gap between the pin and lid (see Figure 6).



5. Verify repairs are complete by opening and closing the lid.airs are complete by opening and closing the lid.



CAUTION:



Do not put any items in the cup holder that could keep the lid from properly closing.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 425

No comments:

Post a Comment