Thursday, February 14, 2019

Steering - Power Steering Hose Service Part Change

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Technical Service Bulletin # 12-030 Date: 120322



Steering - Power Steering Hose Service Part Change



Classification: ST11-008



Reference: NTB12-030



Date: March 22, 2012



ALTIMA, MAXIMA;



POWER STEERING HOSE SERVICE PART CHANGE



APPLIED VEHICLES:2007-2011 Altima (C/L32)



2009-2011 Maxima (A35)



SERVICE INFORMATION



If the high pressure hose on an Applied Vehicle needs to be replaced for any reason:



^ The hose now comes without the pressure sensor (refer to Figure 1).



^ When replacing this hose, reuse the existing pressure sensor. Replace the pressure sensor ONLY IF there is a pressure sensor related issue.



^ Do not replace other related hoses unless necessary (i.e., do not replace as a set).



^ Do not damage the pressure sensor during removal or installation.



^ Always use a new 0-ring when installing a new or existing pressure sensor (refer to Figure 1).



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Page 129



^ Pressure sensor mounting torque: 19.6 Nm (2.0 kg-m, 14.5 ft lb)



^ If only the pressure sensor needs replacement, do not replace any hoses.



^ Always replace both copper washers (mounted at the power steering pump).



CAUTIONS:



> Do not allow dirt or contamination to enter the hydraulic system.



> Always secure the pressure sensor mounting block in a soft jaw vise when removing and installing the pressure sensor. Do not clamp onto



the "banjo" end of the hose.



^ Refer to the appropriate Electronic Service Manual (ESM) for power steering hose removal, installation, and torque specifications.

No comments:

Post a Comment