Thursday, January 17, 2019

Mercedes Benz C 43 AMG Technical Service Bulletin # P-88_30-36 Date: 041008

Mercedes Benz C 43 AMG Technical Service Bulletin # P-88_30-36 Date: 041008



Body - Scraping Noise From Transmission Tunnel Area



Date: October 8, 2004



Order No.: P-B-88.30/36



Supersedes:



Group: 88



SUBJECT:



Model 202.022/023/024/028/029/033



134



Model 203.040/061/064/065/076/081/084/261/264/281/284/740/747/764



Model 210.020/025/055/065/070/072/074/082/083/265/282



Scrapping Noise from Transmission Tunnel Area



If you receive customer reports in the above model vehicles of a scraping noise from the area of the transmission tunnel, the insulation above the



transmission may have warped and is scraping on the propeller shaft. To resolve, perform the below procedure.



1. Make a bracket to support the transmission tunnel insulation by taking a strip of aluminum approximately 2 mm thick.



2. Cut the strip 40 mm wide and 220 mm long.



3. Drill a 6.5 mm diameter hole in the center (Figure 1).



Warning!



Under body components may be hot, use caution.



4. Detach central heat shield above exhaust system and slide toward the rear (Figure 2).



135



5. Remove nut retaining insulation (Figure 3, arrow).



6. Bend aluminum strip to conform with tunnel contour.



7. Fit aluminum strip on threaded stud and reinstall original nut.



8. Reinstall central heat shield above exhaust system.



Note:



The following allowable labor operations should be used when submitting a warranty claim for this repair.



In Case of Warranty, use the table.

No comments:

Post a Comment