Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Technical Service Bulletin # TECLTB00270 Date: 100409

Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Technical Service Bulletin # TECLTB00270 Date: 100409

Suspension - 'Suspension System Inactive' Message

No: LTB00270

Issue: 1

Date: 09 APR 2010

*TECHNICAL BULLETIN LTB00270 REPLACES LTB00250; THERE ARE NO DETAIL CHANGES*

SECTION: 204

Suspension System Software Update When Replacing Compressor

AFFECTED VEHICLE RANGE:

CONDITION SUMMARY:

Situation:

The amber or red suspension warning indicator may illuminate with Suspension System Inactive displayed in the message center or there may be a

noticeable degradation in suspension system performance. If after diagnosis air suspension compressor failure is found and the compressor is

replaced, the Suspension system control module may require a software update.

NOTE:

This suspension system control module software update may only be performed after a suspension system compressor replacement.

Action:

In the event of a suspension system compressor replacement, refer to the Repair Procedure outlined below to update the suspension system control

module software.

PARTS:

No parts necessary

TOOLS:

2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Page 301

IDS with latest DVD and Calibration Files; first available on IDS-DVD119_V8.03 Calibration 21 Land Rover-Approved Midtronics Vehicle Power

Supply

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time. This suspension system control module software update may only be performed after a

suspension system compressor replacement.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal warranty policy and procedures apply.

REPAIR PROCEDURE

UPDATE SUSPENSION SYSTEM CONTROL MODULE SOFTWARE

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the

vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

NOTE:

IDS must be loaded with IDS-DVD119_V8 or later and Calibration File 21 or later.

2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

4. From the Session screen, select the 'Diagnosis tab'.

5. Select the 'Selected Symptoms tab', and then select:

^ Chassis > Suspension system > Vehicle dynamic suspension

6. Select 'continue'.

7. Select the 'Recommendations tab'.

8. Configure the 'Ride level control module'.

^ Follow all on-screen instructions to complete this task.

9. Exit the current session.

10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Page 302