Specified values
- Ignition ON: >3.5 V
- Operate engine at idling speed.(Vacuum> 500 mbar):< 2 V
Question
- Are the measurement values OK?
YES
The measurement values are OK.End of test
NO
The measurement values are not OK.Possible cause and remedy
- Lines to component B28 (Pressure sensor)
- B28 (Pressure sensor)
Further possible causes of fault
- Vacuum line
End of test
1921
SBC : Undervoltage supply
Possible cause:
- N3/10 (ME-SFI [ME] control unit)
Affected functions:
- Battery / On-board electrical system
-------------------------------------------------
Test 1: Check power supply of component N3/10 (ME-SFI [ME] control unit).
Test 2: Check component A7/3n1 (SBC control unit).
1. Check power supply of component N3/10 (ME-SFI [ME] control unit).
Test 1.1: Test voltage supply of circuit 87. ( Check using actual value )
Test 1.2: Test voltage supply of circuit 30.
No comments:
Post a Comment