Warning!Communication with ECU required.
4.2. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Warning!Communication with ECU required.
4.3. Check reference signal of component B2/5 (Hot film mass air flow sensor).
Test sequence
- Switch on ignition.
Status of relevant actual value:
- HFM-SFI ( Reference signal ):Warning! Communication with ECU required.
Specified value
- Reference signal[46...59] ms
Question
- Is the measurement value OK?
YES
The actual value is okay.End of test
NO
The actual value is not o.k.Possible cause and remedy
- Check lines from component N3/10 (ME-SFI [ME] control unit) to component B2/5 (Hot film mass air flow sensor).
- B2/5 (Hot film mass air flow sensor)
4.4. Check power supply of component B2/5 (Hot film mass air flow sensor).
Image legends
- B2/5 (Hot film mass air flow sensor)
- Connector (5-pin)
Test prerequisite
- The actual value is not o.k.
Test sequence
- Switch off ignition.
- Detach coupling at component B2/5 (Hot film mass air flow sensor).
- Measure direct voltage with multimeter between sockets (B2/5) 2 and (B2/5) 1
- Switch on ignition.
Specified value
- Voltage[11.0...15.0] V
Question
- Is the measurement value OK?
No comments:
Post a Comment