- Connect resistance simulator to the connector of component B14 (Ambient temperature display temperature sensor).
- Connect resistance substitution unit between sockets (B14)1 and (B14) 2
- Adjust resistance values one after another and compare them with the actual value.
Status of relevant actual value:
- B14 (Ambient temperature display temperature sensor):Warning! Communication with ECU required.
Specified value
- Resistor9.6 kohms:Temperature: [0锟斤拷 C]
- Resistor5.9 kohms:Temperature: [10锟斤拷 C]
- Resistor3.7 kohms:Temperature: [20锟斤拷 C]
- Resistor2.4 kohms:Temperature: [30锟斤拷 C]
- Resistor1.6 kohms:Temperature: [40锟斤拷 C]
Question:Is the actual value o.k.?
YES
The actual value is okay.Possible cause and remedy
- Component B14 (Ambient temperature display temperature sensor) is defective.
End of test
NO
The actual value is not o.k.Possible cause and remedy
- Check lines from B14 (Ambient temperature display temperature sensor) to N10/1 (Driver-side SAM control unit with fuse and relay module)
for Short circuit or open circuit.
- Component N10/1 (Driver-side SAM control unit with fuse and relay module) is defective.
No comments:
Post a Comment